Commit ed0a06a9 authored by Radomir Dopieralski's avatar Radomir Dopieralski Committed by Damien George
Browse files

docs/esp8266/quickref: Fix and update the SPI docs

Use the `SPI` factory function in the examples, and use
proper baud rate of 80 000 000.
parent 263aaa70
......@@ -165,14 +165,14 @@ Use the ``machine.ADC`` class::
SPI bus
-------
The SPI driver is implemented in software and works on all pins::
There are two SPI drivers. One is implemented in software and works on all pins::
from machine import Pin, SPI
# construct an SPI bus on the given pins
# polarity is the idle state of SCK
# phase=0 means sample on the first edge of SCK, phase=1 means the second
spi = SPI(baudrate=100000, polarity=1, phase=0, sck=Pin(0), mosi=Pin(2), miso=Pin(4))
spi = SPI(-1, baudrate=100000, polarity=1, phase=0, sck=Pin(0), mosi=Pin(2), miso=Pin(4))
spi.init(baudrate=200000) # set the baudrate
......@@ -194,13 +194,13 @@ Hardware SPI
------------
The hardware SPI is faster (up to 80Mhz), but only works on following pins:
``MISO`` is gpio2, ``MOSI`` is gpio13, and ``SCK`` is gpio14. It has the same
``MISO`` is gpio12, ``MOSI`` is gpio13, and ``SCK`` is gpio14. It has the same
methods as SPI, except for the pin parameters for the constructor and init
(as those are fixed).
from machine import Pin, HSPI
from machine import Pin, SPI
hspi = HSPI(baudrate=800000000, polarity=0, phase=0)
hspi = SPI(0, baudrate=80000000, polarity=0, phase=0)
I2C bus
......
Supports Markdown
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment