Commit 1145a070 authored by Dave Hylands's avatar Dave Hylands
Browse files

Change references (in comments) of pyb.GPIO to be pyb.Pin

The documentation at should also be
parent fa2e701e
......@@ -56,7 +56,7 @@
/// Note: ExtInt will automatically configure the gpio line as an input.
/// extint = pyb.ExtInt(pin, pyb.ExtInt.IRQ_FALLING, pyb.GPIO.PULL_UP, callback)
/// extint = pyb.ExtInt(pin, pyb.ExtInt.IRQ_FALLING, pyb.Pin.PULL_UP, callback)
/// Now every time a falling edge is seen on the X1 pin, the callback will be
/// called. Caution: mechanical pushbuttons have "bounce" and pushing or
......@@ -81,7 +81,7 @@
/// Only the IRQ_xxx modes have been tested. The EVT_xxx modes have
/// something to do with sleep mode and the WFE instruction.
/// Valid pull values are pyb.GPIO.PULL_UP, pyb.GPIO.PULL_DOWN, pyb.GPIO.PULL_NONE.
/// Valid pull values are pyb.Pin.PULL_UP, pyb.Pin.PULL_DOWN, pyb.Pin.PULL_NONE.
/// There is also a C API, so that drivers which require EXTI interrupt lines
/// can also use this code. See extint.h for the available functions and
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment