mpconfigboard.h 1.51 KB
Newer Older
Dave Hylands's avatar
Dave Hylands committed
1
2
3
#define NETDUINO_PLUS_2

#define MICROPY_HW_BOARD_NAME       "NetduinoPlus2"
mux's avatar
mux committed
4
#define MICROPY_HW_MCU_NAME         "STM32F405RG"
Dave Hylands's avatar
Dave Hylands committed
5
6
7
8
9
10
11
12
13
14
15
16
17
18

#define MICROPY_HW_HAS_SWITCH       (1)

// On the netuino, the sdcard appears to be wired up as a 1-bit
// SPI, so the driver needs to be converted to support that before
// we can turn this on.
#define MICROPY_HW_HAS_SDCARD       (0)
#define MICROPY_HW_HAS_MMA7660      (0)
#define MICROPY_HW_HAS_LIS3DSH      (0)
#define MICROPY_HW_HAS_LCD          (0)
#define MICROPY_HW_ENABLE_RNG       (1)
#define MICROPY_HW_ENABLE_RTC       (0)
#define MICROPY_HW_ENABLE_TIMER     (1)
#define MICROPY_HW_ENABLE_SERVO     (1)
Damien George's avatar
Damien George committed
19
#define MICROPY_HW_ENABLE_DAC       (0)
20
21
22
#define MICROPY_HW_ENABLE_I2C1      (0)
#define MICROPY_HW_ENABLE_SPI1      (0)
#define MICROPY_HW_ENABLE_SPI3      (0)
Dave Hylands's avatar
Dave Hylands committed
23
24

// USRSW is pulled low. Pressing the button makes the input go high.
25
26
27
28
29
30
31
32
33
34
35
36
37
#define MICROPY_HW_USRSW_PIN        (pin_B11)
#define MICROPY_HW_USRSW_PULL       (GPIO_NOPULL)
#define MICROPY_HW_USRSW_EXTI_MODE  (GPIO_MODE_IT_RISING)
#define MICROPY_HW_USRSW_PRESSED    (1)

// LEDs
#define MICROPY_HW_LED1             (pin_A10)   // Blue LED
#define MICROPY_HW_LED2             (pin_C13)   // White LED (aka Power)
#define MICROPY_HW_LED3             (pin_A10)   // Same as Led(1)
#define MICROPY_HW_LED4             (pin_C13)   // Same as Led(2)
#define MICROPY_HW_LED_OTYPE        (GPIO_MODE_OUTPUT_PP)
#define MICROPY_HW_LED_ON(pin)      (pin->gpio->BSRRL = pin->pin_mask)
#define MICROPY_HW_LED_OFF(pin)     (pin->gpio->BSRRH = pin->pin_mask)